1.Efficacy measures include axial length， keratometric power and mean absolute refractive error.

1.有效测量值包括眼长度，角膜曲率和绝对屈光误差值。

2.Fracture characteristics of axial tension of RCC layer surface are studied experimentally by servohydraulic closed-loop testing machine in laboratory.

2.利用电液伺服式试验机对有层面碾压混凝土试件进行拉断裂试验研究。

3.The finite element models of axial tension member and eccentrical tension members are established with ANSYS finite element program.

3.4、用通用有限元分析软件ANSYS建立了混凝土心和偏心受拉的有限元模，进行分析并得到了受拉构件的应力云图、变形图及开裂图，并与理论分析结果进行了比较。

4.Objective: To discuss the axial image characters of spondyloschisis from vertebral articulations is the purpose of this article.

4.探讨腰椎椎弓部裂与椎间小关节在横断图像上的影像学特征。

5.A two-gap drift tube buncher and a one-gap grid buncher with linear bunching waveform are used on the SFC axial injection line.

5.SFC向注入线采用了一个双间隙漂移管式聚束器和一个单间隙栅网聚束器，分别采用三角波和锯齿波的聚束波形。

6.In general,the cylindrical roller bearings, belonging to axial discerptible bearing,are suitable only for sustaining radial loads.The contact of roller with race is linear.

6.圆柱滚子一般只用于受径向负荷，滚子与套圈滚道为线性接触，属向可分离。

7.Abstract: A two-gap drift tube buncher and a one-gap grid buncher with linear bunching waveform are used on the SFC axial injection line.

7.SFC向注入线采用了一个双间隙漂移管式聚束器和一个单间隙栅网聚束器，分别采用三角波和锯齿波的聚束波形。

8.With greater axial and radial load rating capacity, good replaceability of components. The shaft can be adjusted through external hexogan then to adjust the axial part dimension.

8.径向和向的载能力都比较大，各配件可替换性强。通过调节偏心外六角来调整芯位置进而达到调整侧滚轮向尺寸的目的。

9.The soft-stiff rings of the experimental box are used to ensure axial softness and radial stiffness; the veridical experiments simulate better the one-dimensional plane strain motion.

9.由于采用了软硬环试验箱体以保证箱体的向柔性及径向刚性技术，验证性试验比较好地模拟了介质的一维平面应变运动。

10.Abstract:The exterior tube structure exerts radial outward forces, and the diagrid columns have significant difference in axial force.Both result in large axial tension forces in ring beams.

10.［摘要］重力荷载作用下网筒结构外鼓及交叉柱间力差异将使环梁受到较大的拉力。

11.Rapid application of an axial force completes the upset welds.The localized heating is in high current, low voltage pulses for which a homopolar welding generator is utilized.

11.Electric resistance welding provides localized heating for simultaneous upset welding of the copper bars and copper end rings of an electric motor cage rotor assembly.

12.In order to achieve the fabrication of noninvolute beveloid gears with crossed axes by using the existing machine tools, the tooth profile errors and axial errors should be studied.

12.很多进口机械中应用了交错非渐开线变厚齿轮传动,目前国在该领域的研究还是空白。

13.It is put forward in this paper that the residual strength of overconsolidated soil can be determined by normal routine triaxial testing if its axial load can be controlled exactly.

13.如果能够准确控制向荷重，对超固结土可在常规三仪中测定出残余强度。

14.By observation and analysis of the test data, changing the plate steel endshield of motor into the disc iron one can improve the rigidness of endshield, and reduce the axial vibration of motor.

14.通过观察和检测数据分析,电动机的平板式钢板端盖改为盘式铸铁端盖,可提高端盖刚度,降低电机向振动。